Needs cylinder head gaskets replaced, all hoses and radiator need replaced. System is very rusty.
CYLINDER HEAD GASKET – Remove & Replace – 3.8L Eng Both – [Includes: Remove carbon and check surfaces for warpage. Includes adjust Valves (where applicable) and clean and adjust Spark Plugs.]
CYLINDER HEAD – Pressure Test / Vacuum Test / Resurface / Repair – Both
RADIATOR – Remove & Replace – 3.8L Eng
HEATER HOSES – Remove & Replace – All Hoses – [NOTE: Deduct 0.2 when used in conjunction with Radiator Hose(s) – R&R.]
Cher A. gave our service a 5 star review on 10/17/2022
Horn does not activate when remote is used. All lights will come on and it will lock like normal. Check & Advise.
Removed the left front door panel. Removed the door latch assembly and replaced with new. Reinstalled door panel and rechecked the operation. All checks are ok at this time.
Verified customers concern. Tested and found that the door ajar switch located internal to the door lock assembly is faulty. Reads open at times when it is not open. Recommend replacing the door latch with new.
John E. gave our service a 5 star review on 12/15/2019
Change engine oil & replace oil filter Check P/S Fluid Check & Replace Air Filter, if needed Check Differential Fluids Check Tire Pressure & Wear Check Belts & Hoses Check Transmission Fluid Check Washer Fluid Check Leaks Check Battery Check Transfer Case Fluid Added Fluids As Needed
Front brake linings have 6 mm remaining. Rear brake linings have 5 mm remaining. Front engine mount worn. Cabin air filter dirty. TPMS light illuminated.
Disposal Fee
Zelta T. gave our service a 5 star review on 10/3/2019
Change engine oil and replace oil filter Check P/S Fluid Check and Replace Air Filter, if needed Check Differential Fluids Check Tire Pressure and Wear Check Belts and Hoses Check Transmission Fluid Check Washer Fluid Check Leaks Check Battery Check Transfer Case Fluid Added Fluids As Needed
Scanned the Engine Control Module (ECM) for diagnostic trouble codes and retrieved P0013 – B Camshaft Position Actuator Bank 1. Traced to a failed exhaust camshaft position actuator solenoid. Recommend replacing the intake camshaft position actuator solenoid as well.
Removed the camshaft position actuator intake solenoid valve and replaced with new. Removed the camshaft position actuator exhaust solenoid valve and replaced with new. Cleared the diagnostic trouble codes. Road tested vehicle to verify repairs. Vehicle runs and drives as designed.
Nancy J. gave our service a 5 star review on 11/1/2018