Leaking from valve cover. Recommend valve cover gasket. Leaking from variable valve timing solenoid to valve cover. Recommend variable valve timing solenoid gasket.
32psi in front. 39 psi in rear.
Removed the ignition coils. Removed the valve cover and replaced with new. Replaced the spark plug tubes with new. Cleaned the engine area and rechecked for leaks. No leaks found at this time.
Dolores L. gave our service a 5 star review on 12/30/2021
Evacuate and recharge Removed 1lb 10 oz. Charged 1lb 4oz Low side 35psi. Normal High side 200psi. Normal Temperature 47 degrees Fahrenheit. Dye added to assist with leak detection.
Ralph L. gave our service a 5 star review on 9/15/2021
Change engine oil & replace oil filter Check P/S Fluid Check & Replace Air Filter, if needed Check Differential Fluids Check Tire Pressure & Wear Check Belts & Hoses Check Transmission Fluid Check Washer Fluid Check Leaks Check Battery Check Transfer Case Fluid Added Fluids As Needed
Front brake linings have 10 mm remaining. Rear brake linings have 6 mm remaining. TPMS light illuminated, all tires had 60 psi. Adjusted tire pressures to specification.
Removed the air cleaner element and replaced with new.
Removed the cabin air filter and replaced with new.
Doug S. gave our service a 5 star review on 3/22/2021
Removed the cylinder 2 ignition coil and replaced with new. Cleared the diagnostic trouble codes and road tested vehicle to verify repairs. Vehicle runs and drives as designed.
Scanned the Powertrain Control Module (PCM) for diagnostic trouble codes and retrieved P0302 – Misfire Cylinder 2 Detected. Tested and found that the ignition coil is failed for cylinder 2. Recommend cylinder 2 ignition coil.
Herman D. gave our service a 5 star review on 6/17/2020
Change engine oil & replace oil filter Check P/S Fluid Check & Replace Air Filter, if needed Check Differential Fluids Check Tire Pressure & Wear Check Belts & Hoses Check Transmission Fluid Check Washer Fluid Check Leaks Check Battery Check Transfer Case Fluid Added Fluids As Needed
Check engine light not illuminated at this time. Lamp out message illuminated on the dash. Left side upper brake light is out. Right side outer license plate lamp is out. Scanned the Engine Control Module (ECM) for diagnostic trouble codes. No codes stored in current, history or pending. No problems found at this time.
Front brake linings have 10 mm remaining. Rear brake linings have 8 mm remaining. Left side upper brake light inoperable. Right side license plate lamp inoperable.
Removed the left side upper brake lamp bulb and replaced with new.
Removed the right side license plate lamp bulb and replaced with new.
Disposal Fee
Keith L. gave our service a 5 star review on 3/25/2020
Change engine oil & replace oil filter Check P/S Fluid Check & Replace Air Filter, if needed Check Differential Fluids Check Tire Pressure & Wear Check Belts & Hoses Check Transmission Fluid Check Washer Fluid Check Leaks Check Battery Check Transfer Case Fluid Added Fluids As Needed
Front brake linings have 7 mm remaining. Rear brake linings have 6 mm remaining. Front axle boots are torn. Steering rack showing signs of leaks. Power steering pressure hose showing signs of leaks. Transfer case showing signs of leaks.
Removed the right side rear brake lamp bulb and replaced with new. Lights operate as designed.
Disposal Fee
Leo V. gave our service a 5 star review on 12/5/2019
Inspected the A/C system for leaks, none found. Scanned the control module for any trouble codes, none found. Performed calibration of air flap actuators and scanned temperature data, both sides are as designed.
Performed battery load test, passed. Vehicle starts as designed. Unable to duplicate customers concern at this time.
Adjusted tire pressures to specification. Performed TPMS rest procedure. TPMS light no longer illuminated.
Added washer fluid.
R/F fender wheel area makes a lot of noise.
Yale K. gave our service a 5 star review on 10/26/2018